We service both gas and electric furnace systems with manufacturer-trained technicians.
Flat-rate pricing quoted after diagnosis, no pressure toward a premature system replacement.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Los Angeles, CA carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
We carry manufacturer service manuals for major furnace brands.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
We understand a dead furnace in winter is a pipe-freezing risk, not just a comfort issue.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Los Angeles, CA.
Hot surface ignitors crack over time and simply stop glowing — we test resistance rather than replacing on assumption. This is one of the most requested furnace repair calls we get across Los Angeles, CA.
Faulty gas valves are treated as a safety-critical repair, prioritized accordingly. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
We use a combustion analyzer and visual borescope inspection, not guesswork. This is one of the most requested furnace repair calls we get across Los Angeles, CA.
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
Blocked or improperly sloped venting can back-draft combustion gases into the home. This is one of the most requested furnace repair calls we get across Los Angeles, CA.
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Gas odor reports get immediate safety instructions before dispatch details.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Tech tested the ignitor's resistance right in front of me and swapped it in under thirty minutes.
Turned out to be a failed gas valve — they caught it with a proper pressure test, not a guess.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Yes — our technicians are trained and certified on both fuel types.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
No-heat calls during freeze warnings are prioritized across Los Angeles, CA.

Our furnace repair crews are positioned throughout Los Angeles, CA to keep response times realistic, not just promised.
☎ Call +1-844-611-2875 for Los Angeles Service